Stanley 95 Review By: I.Ball
Category: Specialist Planes
Manufacturer: Stanley
Plane Type: Edge Trimming
Model No: 95
The Stanley Edge Trimming plane number 95.
This plane is used for final trimming of jointed boards.
It allows the planing of smooth edges exactly 90 degrees to the face.
The low angle blade set at a skewed angle allows the planing of end-grain.
It can also plane bevels in a controlled manner.
The plane was made from cast iron and was finished with black japanning.
The early planes had the body cast with 'PAT.5.14.12'.
The Stanley 95 planes are becoming increasingly hard to find.
If you can't find an old Stanley 95 Plane, you may wish to consider
a Veritas Edge Trimming Plane
which is very similar in design.
Length:
6 inch
Cutter:
22mm (7/8 inch)
Weight:
567 g (1 1/4 lbs)
<1914 - 1958>
Date: <1914>
Date: <1934>
Date: <1958>
(i) This review/article may give warning(s) / advisory notes / cautions / guidelines given
in good faith, any such information should not be solely relied upon and seen
as the exhaustive list of warnings / advisory notes / cautions / guidelines. Refer
to good safety practices for the safety of you and others. Refer to good practices
for the good health of your tool and property.
(ii) The details here are given in good faith, the details are constantly growing
and evolving including corrections, there is scope for error and shouldn't be fully relied upon,
please confirm any details for yourself by performing additional research from
reliable sources.
Enjoy viewing the encyclopedia of tools.
If you use info such as dates, sizes, details from FindMyTool.co.uk for certain online
auction sites, forums, video footage, websites and any other forms of media,
please kindly give credit to this site and spread the word so others know
where to find the information.
Please see our terms if using more than a few dates
or details.