Norris 7 Review By: I.Ball
Category: Old Infill Planes
Manufacturer: Norris
Plane Type: Infill
Model No: 7
The Norris steel shoulder reabte plane model number 7.
The Norris 7 plane is a one piece steel shoulder plane fitted with a
rosewood infill, a rosewood wedge and a shouldered cutter.
The Norris 7 was produced in a range of sizes:
- 6" x 1/2" (13mm)
- 7" x 5/8" (16mm)
- 7" x 3/4" (19mm)
- 8" x 1" (25mm)
- 8" x 1 1/8" (29mm)
- 8" x 1 1/4" (32mm)
- 8" x 1 1/2" (38mm)
The wedge slides into the plane until it firmly secures the blade in
position.
A different shaped wedge or a wedge made from a different material
indicates the wedge has been replaced. If the wedge is a different
colour to the infill then this may mean the wedge has been replaced
also.
The Norris number 7 was produced with the standard straight across
mouth and also produced with a skewed mouth at extra cost.
The Norris 7 plane blade cutting section spans the full width of the
plane with the bevel edge side facing upwards.
The plane can be used left or right handed and can be laid perfectly
flat and used on either of its sides to trim rebates, shoulder lines
and tenons.
? - ?
....
Do you have a question/answer or something to share about this tool?
Please Contact Us
(i) This review/article may give warning(s) / advisory notes / cautions / guidelines given
in good faith, any such information should not be solely relied upon and seen
as the exhaustive list of warnings / advisory notes / cautions / guidelines. Refer
to good safety practices for the safety of you and others. Refer to good practices
for the good health of your tool and property.
(ii) The details here are given in good faith, the details are constantly growing
and evolving including corrections, there is scope for error and shouldn't be fully relied upon,
please confirm any details for yourself by performing additional research from
reliable sources.
Enjoy viewing the encyclopedia of tools.
If you are inspired by our content or use info such as dates, sizes,
details from FindMyTool.co.uk
please kindly give credit where credit is due via giving a nod in a video
or a link to this website.
Please see our terms if using more than a few dates
or details.
"Just stumbled across your website and an absolute treasure trove of information.
I was recently given an old Stanley 110 block plane and wanted to know more about it.
Your website told me everything I needed to know.
But there is so much more to read. I forsee me spending a lot of time just reading
page after page. I can appreciate how much time this will have taken to put together.
I just wanted to let you know that your hard work is appreciated."