Stanley Sliding Bevel - No. 18

stanley sliding bevel 18
Our Rating

Stanley 18 Sliding Bevel Review By: I.Ball

Manufacturer: Stanley

Tool Type: Sliding Bevel

Model No: 18 - Eureka


The Stanley sliding bevel number 18, also known as the Stanley Eureka sliding bevel or Stanley Eureka flush T sliding bevel.

The Stanley 18 sliding bevel was nickel plated, made with the following blade sizes:

   - 6"
   - 8"
   - 10"
   - 12"

On the earlier Stanley sliding bevels they were marked 'Stanley' on one side of the stock and 'US Pat 7-14-08' on the rear of the stock.

Probably the most commonly seen versions have the front of the stock marked 'No. 18 Stanley' and the opposite side is marked 'Made In USA'.

stanley sliding bevel 18

Manufactured Dates

1908 - 1929>

stanley eureka sliding bevel 18
stanley eureka sliding bevel 18
stanley sliding bevel 18

Your Say


Do you have a question/answer or something to share about this tool?
Please Contact Us


(i) This review/article may give warning(s) / advisory notes / cautions / guidelines given in good faith, any such information should not be solely relied upon and seen as the exhaustive list of warnings / advisory notes / cautions / guidelines. Refer to good safety practices for the safety of you and others. Refer to good practices for the good health of your tool and property.
(ii) The details here are given in good faith, the details are constantly growing and evolving including corrections, there is scope for error and shouldn't be fully relied upon, please confirm any details for yourself by performing additional research from reliable sources.

Use Of Content

Enjoy viewing the encyclopedia of tools.

If you are inspired by our content or use info such as dates, sizes, details from please kindly give credit where credit is due via giving a nod in a video or a link to this website.

Please see our terms if using more than a few dates or details.


Your AD Here

Copyright © All rights reserved