Stanley Block Plane - No. 9 1/4

stanley block plane 9 1/4
Our Rating

Stanley 9 1/4 Review By: I.Ball

Manufacturer: Stanley

Plane Type: Block

Model No: 9 1/4


The Stanley block plane number 9 1/4 is a 6 inch long block plane made with a grey cast iron body, a hooded lever cap, a brass (or alloy) front knob, a lateral blade adjuster and a brass depth adjusting wheel nut.

The body has a black jappaned finish on the top-side, as standard for Stanley planes. The sides and sole of the plane are machined and ground to be flat and true. The centre of the sides also have an oval shaped indentation either side to act as additional finger grips.

The 9 1/4 plane has a 1 5/8 inch blade which sits on a 20 degree bed, making this a low angle block plane.

The Stanley 9 1/4 plane blade has a series of grooves on the rear side of the blade, towards the top end which locate into the lateral blade adjuster mechanism.

stanley block plane 9 1/4

Once the blade is located correctly, the depth of cut can be set by turning the brass depth adjuster wheel nut at the rear of the plane (note: ensure the lever cap is removed before adjusting).

The hooded lever cap locks the blade in place by sliding the lever sideways.

The blade can also be adjusted laterally using the lateral lever adjuster. The lateral lever adjuster is found behind the top of the blade, just above the brass depth adjuster wheel nut. The lateral lever pivots left and right which in turn adjusts the blade left and right.

The plane has a brass (or alloy) front knob with a depressed surface designed as a finger grip.

What Is The Difference Between The Stanley 9 1/4 Block Plane And The Stanley 9 1/2 Block Plane?

The Stanley 9 1/4 block plane is exactly the same as the Stanley 9 1/2 block plane with the exception the Stanley 9 1/4 plane has a fixed mouth whereas the 9 1/2 plane has an adjustable mouth. The 9 1/4 also doesn't have the lever for adjusting the adjustable mouth (as there isn't an adjustable mouth). This mouth adjusting lever is wrapped around the front knob of the 9 1/2 block plane.

Manufactured Dates

<1949 - 1960>

Your Say


Do you have a question/answer or something to share about this tool?
Please Contact Us


(i) This review/article may give warning(s) / advisory notes / cautions / guidelines given in good faith, any such information should not be solely relied upon and seen as the exhaustive list of warnings / advisory notes / cautions / guidelines. Refer to good safety practices for the safety of you and others. Refer to good practices for the good health of your tool and property.
(ii) The details here are given in good faith, the details are constantly growing and evolving including corrections, there is scope for error and shouldn't be fully relied upon, please confirm any details for yourself by performing additional research from reliable sources.

Use Of Content

Enjoy viewing the encyclopedia of tools.

If you are inspired by our content or use info such as dates, sizes, details from please kindly give credit where credit is due via giving a nod in a video or a link to this website.

Please see our terms if using more than a few dates or details.


Your AD Here

Readers Pick

"Just stumbled across your website and an absolute treasure trove of information. I was recently given an old Stanley 110 block plane and wanted to know more about it. Your website told me everything I needed to know.

But there is so much more to read. I forsee me spending a lot of time just reading page after page. I can appreciate how much time this will have taken to put together.

I just wanted to let you know that your hard work is appreciated."

Copyright © All rights reserved